Roof pitches and overhangs may vary as necessitated by architectural design; however, no flat roofs are allowed as a major structural element. A minimum 5 to 12 slope is set as a standard. Roof overhangs are recommended to protect from the sun, and along with trellises, will provide passive energy conservation. No mansard roofs will be allowed.
All roof stacks, flashings, vents or protrusions from the roof shall be painted deep gray or the same color the roof will be at maturity. Roof stacks and plumbing vents shall be placed on rear slopes of the roofs where possible.
Solar water heating panels shall be reviewed on an individual basis and approval based upon the visual effect to the surrounding area. Generally their use is discouraged.
Roofing materials, depending on the neighborhood, may be architectural dimensional composite shingles, cedar or pressure treated wood shingles or shakes, slate, tile or prefinished metal. Combinations of shingles and metal roofing may be allowed when appropriate to the architectural character of the house. Roofing colors must be approved by the NCC.
Houses with pitched roofs of a minimum pitch of 9 in 12 and a maximum pitch of 12 in 12 are encouraged. Special cases will be considered by the NCC if in keeping with the architectural character of the house and neighborhood. Shed roofs for porches may have a lower pitch, but in no case will the pitch be lower than 3.75 in 12. Houses may have gabled, hipped, or shed roofs. House gables may be a full return Queen Anne return with the returns preferably capped in copper. Exposed rafter tails are allowed, but the design must be approved by the NCC.
Gable and decorative roof vents shall be in keeping with the architectural character of the house. Ridge vents, if used, must be of the “shingle over” design extended to the outer edge of the roof ridge. Tile ridge caps are allowed over dimensional roof shingles. Soffit venting visible from the street shall be of similar material to that of the porch or entry stoop ceiling and must be submitted to the NCC for approval.
Special metal roofing applications may be considered by the NCC when appropriate.
